SERIES 70 ELECTRIC ACTUATOR
Installation, Operation, and Maintenance Manual
18 of 48
© 2022 BRAY INTERNATIONAL, INC. ALL RIGHTS RESERVED. BRAY.COM
The Information contained herein shall not be copied, transferred, conveyed, or displayed in any manner
that would violate its proprietary nature without the express written permission of Bray International, Inc.
STORAGE
WARNING
Actuators are not weatherproof unless they are properly installed on the valve or
prepared for storage Bray cannot accept responsibility for deterioration caused
on-site
Bray Series is not weatherproof until the unit is properly installed or all conduits
and applicable port connections are sealed o and prepared for storage The units
may be shipped with temporary covers to prevent foreign matter from entering
through the conduit openings however the user is responsible for replacing with
the proper sealing plugs to support its NEMAIP ratings
To prevent condensation from forming inside the unit maintain a near constant
external temperature and store indoors in a well ventilated clean dry room
The temperature shall be between F (C) and F (C) with a relative
humidity less than
Store units away from vibration and direct sunlight exposure and place units on a
shelf or wooden pallet in order to protect against dampness
Keep units covered to protect against dust and dirt if storing for long term placing
the unit inside a plastic sealed bag may be preferred
Bray cannot accept responsibility for deterioration caused on-site once the cover is
removed or due to improper storage
For units with an internal heater power should be supplied to the heater via conduit
entry with an appropriate sealing gland
To Next Page
Loading...
Need help?
General
