67XXU USB/Serial Scale Service Manual 33
4.6 Display Software and Hardware Version
Display the current version of software and hardware.
1. Enter the Setup Mode by pressing the [HOLD] + [ON/OFF] keys until confg is
displayed.
2. Use the [UNIT] key to select the MISC-VER menu.
3. Press [TARE] to display the current version.
3a. Firmware Version display Format is: Vxx.yy, xx is hardware version, yy is
software version.
4. Press the [ON/OFF] key to return to last menu item.
4.7 Display Test
1. Press the [HOLD] + [ON/OFF] keys until confg is displayed.
1. Use the [UNIT] key to select TEST-DSP.TS menu.
2. Press [TARE] to enter the test display mode and all segments will light at first.
2a. In this mode, every press of the [UNIT] key will light the next segment. Every
press of the [HOLD] key will light the next digit.
2b. Press the [TARE] key to automatically light all segments and all digits.
3. Press the [ON/OFF] key to return to last menu item.
To Next Page
Loading...
