FILTERING TIPS
COMPLAINT CAUSE REMEDY
Motor will not start
WARNING: Turn
cook/filter switch to
OFF position to avoid
splashing of oil when motor
protector reset button is
pushed.
1. Overload tripped
2. Cook/filter switch OFF
3. Open or faulty wall fuse or
circuit breaker
1. Wait for overload to cool.
Push red motor protector
reset button located on
rear of motor.
2. Turn to FILTER
3. Check wall fuse or circuit
breaker
Motor hums but will not start
1. Solidified shortening in
pump
2. Crumbs in pump
1. Turn cook/filter switch
OFF. Contact service
person.
2. Turn cook/filter switch
OFF. Contact service
person.
Motor starts but will not
pump
1. Filter pan not completely
installed
2. O-ring on riser line not
installed
3. Solidified shortening in
piping or filter pan
1. Firmly push filter pan in
2. See FILTERING
3. Turn cook/filter switch
OFF. Contact service
person.
Motor starts but will not
pump or stops at any level
1. Filter paper or hold down
improperly installed
2. Not using enough
Broaster
®
filtering com-
pound
1. See COOKING OIL
CARE AND FILTERING
2. Add Broaster
®
filtering
compound
Motor starts but stops
pumping when oil is level
with top of hold down,
approximately 1 inch of oil in
bottom
1. Filter paper improperly
installed or crumbs under
filter paper or hold down
1. See COOKING OIL
CARE AND FILTERING
14 - 7
Manual #13897 10/97 Rev 9/05
To Previous Page
Loading...
