Atmospheric Single-Arm Robot Introduction
User’s Manual Specifications
Brooks Automation
Revision 1
1-15
plate should be at least 0.5 in (12.5 mm) thick if made from aluminum and 0.38 in (9.6
mm) thick if made from steel.
Bottom mount robots mount on a base plate in the host equipment. Four user-sup-
plied #1/4-20UNC or M6 cap screws secure the robot to the base plate. The plate
should be at least 0.5 in (12.5 mm) thick if made from aluminum and 0.38 in (9.6 mm)
thick if made from steel.
Vacuum Specifications
The recommended vacuum source is 25-in. Hg at > 1 SCFM freeflow.
Seismic Specifications
The robot should be bolted firmly into the system where it is being used.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
