Brother BC800 - Bobbin Winder Assembly Attachment

3 - 5
Main parts
Main unit
Assembly
5 Bobbin winder assembly attachment
1. Attach the rubber ring 1 to the bobbin winder pulley.
2. Insert the bobbin winder shaft 2 into the groove on the arm bed cover, and
secure the shaft with the 2 screws 1.
3. Insert the BW switch lever 3 into the bobbin winder shaft stopper 4.
4. Set the bobbin winder spring 5 and then the bobbin winder shaft stopper
4 to the stopper attachment section of the arm bed cover, and secure them
with the screw 2.
*Key point
• Check that the bobbin winder spindle base passes over the
bobbin winder spring when the bobbin winder is switched.
• Check that the bobbin winder spring returns to the original
position when the bobbin winder is switched.
1
2
Torque
1.18 – 1.57 N
·m
2
54 6
1
14
2
Giza Tite
5X16
Color; Gold