5-21
Confidential
3.3 Wireless LAN setting (Wireless Network Model only)
When the printer is in the ready state, you can switched to the Effective/Invalidity of the
wireless LAN setting by pressing the [Go] button for ten seconds.
<Procedure>
(1) Keep the [Go] button pressed down in the ready state, and check the lighting of the
Toner LED, Drum LED, Error LED and Ready LED in this order. Keep the [Go] button
pressed down, and Start the printing of the wireless network information after lighting off
the Toner LED, Drum LED and Error LED. And switch to the Effective/Invalidity of the
wireless LAN setting
(2) Release the [Go] button.
(3) It is switched to a set value opposite to a current set value, whenever switching. and
then the wireless network information (Network Configuration) printing is implement.
Check that which of wireless LAN or wired LAN became effective. Judge by the Active or
Inactive from “Node Type” which is mentioned in “Network Configuration” of “Printer
Settings”.
3.4
Wireless Connecting Diagnostic Report Print (Wireless Network Model only)
When press the [Go] button five times in the ready state, print the Wireless Connecting
Diagnostic Report Print (WLAN report).
Fig. 5-6
CAUTION :
• When keep the [Go] button pressed down in the procedure (2), Start the lighting of
the Toner LED, Drum LED, Error LED and Ready LED in this order. And switch to a
set value opposite. Then, the setting is not changed even if it continues pushing the
[Go] button.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
