Brother HL-S7000DN - Page 88

General Information
82
3
Print Position X Offset -500 / -499 / ... / -1 / 0* / 1 /
... / 499 / 500Dots
Moves the print start position (at the
top-left corner of pages) horizontally up
to -500 (left) to +500 (right) dots in
300 dpi.
Y Offset -500 / -499 / ... / -1 / 0* / 1 /
... / 499 / 500Dots
Moves the print start position (at the
top-left corner of pages) vertically up to
-500 (up) to +500 (down) dots in
300 dpi.
Auto FF - On / Off* Allows you to print the remaining data
without pressing Go.
HP LaserJet Font No. I000 / ... / I059* / ... / I071 Sets the font number.
Font Pitch 0.44 / ... / 10.00* / ... /
99.99
Sets the font pitch.
Font Pitch menu will appear when
you choose I059 to I071 in the
Font No. setting.
Font Point 4.00 / ... / 12.00* / ... /
999.75
Sets the font size.
Font Point menu will appear when
you choose I000 to I058 in the
Font No. setting.
Symbol Set PC-8* / PC-8 D/N / ... Sets the symbol set or the character
set.
Table Print - Prints the code table.
If Change Emulation appears on the
LCD, choose Auto or HP LaserJet in
Emulation of the Print Menu.
(See page 81.)
Auto LF On / Off* ON: CR i CR+LF, OFF: CR i CR
Auto CR On / Off* ON: LF i LF+CR, FF i FF+CR, or
VT i VT+CR
OFF: LF i LF, FF i FF, or VT i VT
Auto WRAP On / Off* Chooses whether a line feed and
carriage return will happen when the
machine reaches the right margin.
Auto SKIP On* / Off Chooses whether a line feed and
carriage return will happen when the
machine position reaches the bottom
margin.
Left Margin ## Sets the left margin at column 0 to 70
columns at 1 cpi. The default setting is
0 cpi.
Print Menu (continued)
Submenu Menu Selections Options Descriptions
The factory settings are shown in Bold with an asterisk.