Brother MFC-9330CDW Advanced User's Guide

70
Cleaning the drum unit A
If your printout has black or white dots or
other repeating marks at 3.7 in. (94 mm)
intervals, the drum may have foreign
material, such as glue from a label stuck on
the drum surface. Follow these steps to solve
the problem.
a Make sure the machine is in the Ready
mode.
b Press .
c Press All Settings.
d Swipe up or down, or press a or b to
display Print Reports.
e Press Print Reports.
f Swipe up or down, or press a or b to
display Drum Dot Print.
g Press Drum Dot Print.
h The Touchsceen will show
Press [OK].
Press OK.
i The machine will print the Drum Dot
Check Sheet. Then press .
j Press and hold down to turn off the
machine.
k Open the top cover until it locks in the
open position.
l The color of printed dots is the color of
the drum you should clean. Remove the
toner cartridge and drum unit assembly
of the color causing the problem.

Brother MFC-9330CDW Specifications

Print Specifications

print speed black	up to 23 ppm
print speed color	up to 23 ppm
print resolution	up to 600 x 2400 dpi

Copy Specifications

copy speed black	up to 23 cpm
copy speed color	up to 23 cpm
copy resolution	600 x 600 dpi

Scan Specifications

scan resolution optical	1200 x 2400 dpi
scan resolution interpolated	19200 x 19200 dpi
document glass size	8.5” x 11.7”

Fax Specifications

fax modem speed	33.6k bps
fax page memory	up to 500 pages
speed dial locations	200

Paper Handling

auto document feeder capacity	up to 35 pages
paper size maximum	up to 8.5” x 14” (legal)
standard paper capacity	250 sheets

Power and Energy

deep sleep mode power consumption	<2W
automatic duplex printing	Yes
energy star qualified	Yes