Brother MFC-J2310

Chapter 6
58
e Press Setup Receive.
f Press s or t to display
Remote Codes.
g Press Remote Codes.
h Press On.
i Do one of the following.
 If you want to change the Remote
Activation Code (Act.Code), enter
the new code.
Press OK, go to step j.
 If you do not want to change the
Remote Activation Code, press OK,
go to step j.
j Do one of the following.
 If you want to change the Remote
Deactivation Code (Deact.Code),
enter the new code.
Press OK, go to step k.
 If you do not want to change the
Remote Deactivation Code, press
OK, go to step k.
k Press .
NOTE
• If you are always disconnected when
accessing your external TAD remotely, try
changing the Remote Activation Code and
Remote Deactivation Code to another
three-digit code using the numbers 0-9, l ,
#.
• Remote Codes might not work with some
telephone systems.