PhotoCapture Center™: Printing photos from a memory card or USB Flash memory drive
61
8
Restoring all settings to the
factory settings 8
You can restore the PhotoCapture settings
that you have changed, to the factory
settings, such as Print Quality,
Paper Type, Paper Size, Brightness,
Contrast, Color Enhance, Cropping,
Borderless and Print Date.
a Open the media slot cover.
b Put the memory card or USB Flash
memory drive in the correct slot.
c Do one of the following:
Press View Photos and press
s or t on the Touchpanel to display
each photo. When the photo you
want to print is displayed, press OK.
Press Print All.
d Press Options.
e Press s or t to display
Factory Reset.
f Press Factory Reset.
g The Touchscreen asks you to confirm to
change back to the factory settings.
Press Yes to confirm.
h Press .
Scan to a memory card
or USB Flash memory
drive
8
How to set a new default 8
You can save the Scan to Media settings
(Scan Type, Resolution, File Type
and Remove Background) you use most
often by setting them as the default settings.
These settings will remain until you change
them again.
a Open the media slot cover.
b Put the memory card or USB Flash
memory drive in the correct slot.
c Press .
d Press (Scan).
e Press s or t on the Touchpanel to
display Scan to Media.
f Press Scan to Media.
g Press Options.
h Press Scan Type, Resolution,
File Type or Remove Background.
Then press the option you want to set.
Repeat this step for each setting you
want to change.
i After you are finished choosing your
preferred settings, press s or t to
display Set New Default.
j Press Set New Default.
k Press OK.
The Touchscreen asks you again to
confirm that you want to set the changes
as the new default settings.
Press Yes.
l Press .
To Next Page
Loading...
Need help?
General
