Brother MFC-J4310DW - Cleaning the Paper Pick-Up Rollers

70
d Put the paper tray firmly back in the
machine.
e Re-connect the power cord.
NOTE
Do not use the machine again until the
rollers are dry. Using the machine before
the rollers are dry may cause paper feed
problems.
Cleaning the paper pick-up
rollers A
a Unplug the machine from the AC power
outlet.
b Pull the paper tray completely out of the
machine.
NOTE
If the machine starts to multi-feed the last
few sheets of paper in the tray, clean the
Base Pad (1) with a soft lint-free cloth
moistened with water.
After cleaning, wipe the pad with a dry,
soft lint-free cloth to remove all moisture.
c Clean the Paper Pick-up Rollers (1) with
a soft lint-free cloth moistened with
water.
Slowly turn the rollers so that the whole
surface is cleaned.
After cleaning, wipe the rollers with a
dry, soft lint-free cloth to remove all
moisture.
d Put the paper tray firmly back in the
machine.
e Re-connect the power cord.
1
1