Brother MFC-J4310DW - Page 32

Configuring your machine for a wireless network
26
3
i Press Infrastructure when instructed.
j Choose and press the Authentication method.
Do one of the following:
If you choose Open System, go to step k.
If you choose Shared Key, go to step l.
If you choose WPA/WPA2-PSK, go to step m.
k Choose and press the Encryption type None or WEP.
Do one of the following:
If you choose None, go to step o.
If you choose WEP, go to step l.
l Enter the WEP key you wrote down in step a on page 25. Press OK. Go to step o. (For information on
how to enter text, see the Quick Setup Guide.)
m Choose and press the Encryption type, TKIP or AES. Go to step n.
n Enter the WPA key you wrote down in step a on page 25 and press OK. Go to step o. (For information
on how to enter text, see the Quick Setup Guide.)
o To apply the settings, press Yes. To cancel, press No.
Do one of the following:
If you choose Yes, go to step p.
If you choose No, go back to step g.
p The machine starts to connect to the wireless device you have chosen.
q A connection result message appears for 60 seconds on the LCD and a wireless LAN report will
automatically be printed. If the connection failed, check the error code on the printed report.
See Quick Setup Guide: Troubleshooting
(Windows
®
)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please choose Install MFL-Pro Suite from
the CD-ROM menu.
(Macintosh)
You have completed the wireless network setup. If you would like to continue installing drivers
and software necessary for operating your device, please double-click Start Here OSX in the
CD-ROM.