Brother MFC-J4310DW - Configuration in Ad-Hoc Mode; Configure the Wireless Settings

Configuring your machine for a wireless network
27
3
Configuration in Ad-hoc Mode 3
Configure the wireless settings 3
(For MFC-J2510/J4510DW/J4710DW) 3
a Before configuring your machine we recommend you write down your wireless network settings. You will
need this information before you continue with the configuration.
Check and record the current wireless network settings.
NOTE
The wireless network settings of the computer you are connecting with must be set to Ad-hoc mode with
an SSID already configured. For instructions on how to configure your computer to Ad-hoc mode please
see the information included with your computer or contact your network administrator.
b Press .
c Press All Settings.
d Press Network.
e Press WLAN.
f Press Setup Wizard.
g When Switch Network interface to wireless? is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
SSID (Network Name):
Communication Mode Encryption mode Network key
Ad-hoc WEP
NONE —
For example:
SSID (Network Name):
HELLO
Communication Mode Encryption mode Network key
Ad-hoc WEP 12345678