Brother PJ-822 - Page 150

General Tab
Communication Settings
Network Settings on Power On (PJ-883)
Specify the conditions for connecting via network when the printer is turned on.
Selected Interface (PJ-883)
Select the Infrastructure, Infrastructure and Wireless Direct, or Wireless Direct option.
Bluetooth on Power On
Specify the conditions for connecting via Bluetooth when the printer is turned on. Select the On by Default,
Off by Default, or Keep Current State option.
IPv6 (PJ-883)
IPv6 usage
Select Enable or Disable.
Priority on IPv6 address
Select to give priority to an IPv6 address.
AirPrint Settings (PJ-883)
Enable or disable AirPrint, and configure the settings.
Wireless LAN Tab (PJ-883)
TCP/IP (Wireless)
Boot Method
Select the AUTO, BOOTP, DHCP, RARP, or STATIC option.
IP Address/Subnet Mask/Gateway
Specify the various networking values. You can enter these settings only when the IP address is set to
STATIC.
DNS Server Method
Select the AUTO or STATIC option.
Primary DNS Server IP Address/Secondary DNS Server IP Address
You can enter these settings only when the DNS server is set to STATIC.
IPv6
Static IPv6 Address
Specify a permanent IPv6 address.
Enable this address
Enables the specified static IPv6 address.
Primary DNS Server IPv6 Address
/Secondary DNS Server IPv6 Address
Specify the DNS server IPv6 addresses.
IPv6 Address List
Displays the list of IPv6 addresses.
Wireless Settings
Communication Mode
Displays communication mode.
146