96
Predelivery
Operational Checks
I-Command — The I-Command system self-tests
by displaying the Evinrude E-TEC welcome
screen, followed by the default digital display.
SystemCheck — The SystemCheck monitor self-
tests by sounding a half-second beep. System-
Check gauges self-test by turning the indicator
lights on simultaneously, then off in sequence.
Water Pump Overboard Indicator
A steady stream of water should flow from the
overboard indicator.
Operating Temperature
An outboard run at idle speed should achieve a
temperature based on the engine’s thermostatic
control. In general, the powerhead temperature
should reach at least 104°F (40°C) after five min-
utes of idling. Check that the powerhead reaches
idle temperature.
Leaks
Perform running checks of the as follows:
• Start outboard.
• Inspect all fuel hoses and connections.
• Inspect all oil hoses and connections.
• Inspect all cooling water hoses and connec-
tions.
• Repair any leaks or misrouted hoses immedi-
ately.
Idle Speed
Make sure the outboard idles within the specified
idle RPM range. If the outboard is run on a flush-
ing device, the idle speed and quality may not be
representative of actual in water use.
Break-In
Evinrude E-TEC G2 outboards require no break
in. When the outboard is delivered, refer the cus-
tomer to the Oiling System information in the
Operator’s Guide.
1. Water pump overboard indicator
009128
To Next Page
Loading...
