Bryant Evolution Connex Control User Manual

20
5.4.1. Hydronic Heat Application
The Evolution Connex Control supports two types of Hydronic Heat applications:
1. Hot water coil in combination with an FE fan coil and heat pump, or hot
water coil as sole heat source with an FE fan coil.
2. Non--zoned FE fan coil combined with radiant hot water heat.
In either application, a Hydronic Heat kit should be installed in place of an electric
heater. See FE fan coil Product Data for accessory part number. The system will
self--identify that hydronic heat has been installed during electric heater selection.
The system will treat the hot water coil as either auxiliary heat in a heat pump
application, or the sole heat source. Setup options for Hydronic Heat applications
are described in the setup section of this instruction.
NOTE: The daily airflow verification test will take place even when the radiant
hydronic heat option is selected.

Bryant Evolution Connex Control Specifications

General

Brand	Bryant
Model	Evolution Connex Control
Category	Thermostat
Language	English