75
6.5.9. Run/Fault History
This information is stored in the equipment circuit boards (if communicating) and
displayed on the control. The indoor unit and outdoor unit (if communicating) have
the following histories. To return to the previous screen, touch BACK.Toexitthe
Service menus, touch DONE.
S Resettable Faults: Fault counters for each piece of equipment that can be reset.
S Cycle Counters: Number of heat/cool/power cycles the unit has performed.
S Run Times: Lifetime hours of operation in heating, cooling, and how long the
unit has been powered.
A12202
6.5.10. Model/Serial Numbers
This menu item allows the installer to view the model number, serial number (if
available), and control software version (if available) of all communicating pieces
of equipment in the system, including the wall control. This information resides in
the original equipment circuit board(s) from the factory. If an equipment circuit
board has been replaced, the model and serial number will no longer be displayed.
To return to the previous screen, touch BACK. To exit the Service menus, touch
DONE.
To Next Page
Loading...
