BST eltromat ekrPro Com60 - Table of Contents

Quick Reference Guide QRG
Qick Reference Guide EDV no.: MD.337.01.04
ekrPro Com60 with CLS Pro 600 Issue date: 30.06.2011
Contents
Contents .......................................................................................... 2
1 System overview ....................................................................... 1
2 Commissioning ekrPro Com
60
.................................................. 1
2.1 Actuator EMS 17 – EMS 22 ................................................... 4
2.1.1 Select actuator .................................................................... 4
2.1.2 Setting the actuator guiding direction ................................. 5
2.1.3 Select servo-center component .......................................... 5
2.1.4 Setting the actuator path limits ........................................... 6
2.2 Actuators EMS 3 / 4 ............................................................... 7
2.2.1 Select actuator .................................................................... 7
2.2.2 Setting the actuator guiding direction ................................. 8
2.2.3 Check the limit switch allocation ......................................... 8
2.2.4 Select the servo-center component .................................... 9
2.3 Hydraulic actuator .................................................................. 9
2.3.1 Select hydraulic actuator .................................................... 9
2.3.2 Setting the actuator guiding direction ............................... 10
2.3.3 Select the servo-center component .................................. 12
3 Setting up the CLS Pro 600 .................................................... 13
3.1 General ................................................................................ 13
3.2 Requirements ....................................................................... 13
3.3 Adjust password level .......................................................... 14
3.4 Configuration ........................................................................ 15
4 Material Setup ......................................................................... 17
4.1 at the controller .................................................................... 17
4.2 at the sensor ........................................................................ 17
4.3 Edge set-up mode ................................................................ 18
4.4 Line setup mode .................................................................. 19
5 Job administration ................................................................... 20
5.1 Selecting a job ..................................................................... 21
5.2 Creating and saving a job .................................................... 21
5.3 Deleting a job ....................................................................... 21
5.4 To show the current job ....................................................... 22