If you experience any problems, please call the Helpline on Freephone 0808 100 6554* or visit www.bt.com/producthelp
Setting up 17
Removing the battery
If you ever need to remove the battery, unplug
the power adaptor and then open the battery
compartment cover. Move the battery release tab
(see diagram on page 16 for position) to the right to
release the battery.
3. Plug the power adaptor cable (item code 064761)
into the socked marked
on the side of the
Parent unit and plug the other end into the mains
power and switch on. The
light on the front
of the Parent unit will turn on while the battery
is charging.
4. Leave the battery to charge continuously for 12
hours before you switch the Parent unit on. When
the battery is fully charged the light on the side of
the Parent unit will turn off.
The Parent unit rechargeable
battery will lose charge over
a period of time, even if
switched off.
If the Parent unit is not going
to be used for a long time,
remove the battery to prevent
any possible leakage.
Battery low warning
When the battery is low the
screen will display
Battery
low at Parent unit and the
icon. The
light will
also flash and you will hear
a short alert beep. You will
need to recharge the Parent
unit without interruption for
approximately 30 minutes to
give the Parent unit enough
charge to use for a short time.
If the Parent unit is turned off
during charging, the battery
will charge more quickly.
WARNING
Only use the power adaptor
supplied. Using an incorrect
power adaptor could
permanently damage
your product.
To Next Page
Loading...
Need help?
General
