Setting up
If you experience any problems, please call the Helpline on Freephone 0808 100 6554* or visit www.bt.com/producthelp
18
5. Once the Parent unit battery has fully charged,
press the
button on the Parent unit until the
screen becomes active. The battery icon on the top
line of the screen will be solid to indicate that the
battery is fully charged
.
Baby unit
The Baby unit can be powered up using the power
adaptor provided or using 4 AA batteries (not
supplied). Even if the power adaptor is used, we
recommend that you also install batteries to guarantee
continual operation in the case of a power cut.
1. Install 4 AA batteries (not supplied) into the
battery compartment as shown observing the
polarity markings inside. Then replace the battery
compartment cover.
WARNING
Do not mix old and new
batteries. Only use the
recommended type of 4 AA
batteries. Using other types
could permanently damage
the unit.
Battery performance
The operating time for using
AA batteries is approximately
8 hours depending on light
conditions and feature usage.
Therefore, if you want to
monitor your baby for long
periods we strongly recommend
you connect the power adaptor
to the Baby camera unit.
Make sure the Parent unit
and power adaptor cable are
kept away from the reach
of children.
You can charge the battery
when the Parent unit is
switched on but this will
extend the charging time.
To Next Page
Loading...
Need help?
General
