If you experience any problems, please call the Helpline on Freephone 0808 100 6554* or visit www.bt.com/producthelp
Setting up 21
If no connection can be
established, the Parent unit
will display No link to CAM for
a few seconds, then Waiting
for linking…
The Link light will
continue to flash.
Testing the units before use
It is important that you test the units before use and
at regular times thereafter, especially if they have
not been used for some time.
To test your units
1. Place the Parent and Baby units in the same room
but make sure they are at least 2 metres apart.
2. Press and hold the
button on the Baby unit
until the Power light on the button turns on.
3. Press and hold the
button on the Parent unit
until the display shows Waiting for linking and the
Link light flashes.
4. Press the
button on the Parent unit to view
the image from the Baby unit.
Pairing the units
The Parent and Baby unit supplied are already
paired. You can add or replace Baby units purchased
separately to your baby monitor system. You can
pair a maximum of four Baby units to your Parent
unit. Each new Baby unit must be paired to the
Parent unit before use, see page 40 for instructions.
To Next Page
Loading...
Need help?
General
