BT 1000 User Guide

16
If you experience any problems, please call the Helpline on Freephone 0808 100 6554* or visit www.bt.com/producthelp
16
Setting up
Parent unit
1. Remove the plastic protective film from the front of
the unit.
Insert the battery supplied into the battery
compartment. It will only fit one way round.
Antenna
Release
2. Replace the battery compartment cover by aligning
the cover flat against the battery compartment,
then slide it towards the centre of the Parent unit
until it clicks into place.
Antenna
Release
WARNING
Only use the battery supplied.
Using another type could
permanently damage the unit.
Battery performance
The operating time for using the
rechargeable battery is limited. It
will last for approximately 6 hours
in standby mode but this will vary
depending on the sensitivity level
you have set, your actual use and
the age of the battery. Therefore,
if you want to monitor your baby
for long periods we strongly
recommend you connect the
power adaptor to the Parent unit,
especially at night.
Please note that new batteries
do not reach full capacity until
they have been in normal use
for several days. The charge
capacity of rechargeable
batteries will reduce with time as
they wear out, so reducing the
performance time of the Parent
unit. Eventually they will need to
be replaced. New batteries can
be obtained from the BT Digital
Video Baby Monitor 1000
Helpline on 0808 100 6554*.
Battery
release tab

BT 1000 Specifications

General

Type	Cordless Telephone
GAP Compatible	Yes
Phonebook entries	50
Caller ID	Yes
Call Waiting	Yes
Redial	Yes
Talk time	10 hours
Number of Handsets	1
Answering Machine	No
Standby time	Up to 100 hours
Indoor range	50m