BT UPS Enterprise SNMP Agent
Issued by: BT
Version no: 6.1
Date: March 2019
5.2.8 2.2.6 Email
This page is to set Email details for use by NetAgent.
NetAgent CP、DP series only support SMTP
NetAgent BT、CT、DT series and NetAgent 9 series of BX、CX、DX supports SMTP and
SSL SMTP。
5.2.8.1 Email Setting
Email Server This section is to set NetAgent Email Server . Note that free email server such
as Hotmail, yahoo, Gmail is not allowed
Email Port
This is to configure the SMTP port to send email
Sender’s Email Address
This section is to set NetAgent’s Email address.
Email Server Requires Authentication
This section is to set whether the Email Server requires authentication.
Account Name
This section is to set an Email account name when the email server requires authentication.
Password
This section is to set a password when the email server requires authentication.
Sending test mail
This is to send a test mail by clicking on Test Mail to the mail address configured
5.2.8.2 Recipient’s Email Address (for Event Log)
This section is to set Email Addresses to receive warning email sent by NetAgent when an
event occurs. It is valid for up to 8 Email addresses.
Send Email When Event Occurs
This section is to set NetAgent to send warning Email when an event occurs.
Account 1~8
8 email addresses could be configure with selected event
Event
This section is to select events for NetAgent to send warning email. Clicking on Select will
open a Select Events List. Event email may be selected from this list. (The list is the same as
under SNMP setting. Please refer to page 35, figure 31)
To Next Page
Loading...
Need help?
General