BT UPS Enterprise SNMP Agent
Issued by: BT
Version no: 6.1
Date: March 2019
2 NetAgent UPS Installation
Before using the NetAgent, the proper hardware and software configuration is necessary.
Hardware installation is to connect the NetAgent and UPS and network. Software
configuration includes the IP address. Firmware upgrade. Or using the Browser or Telnet for
configuration.
You could also install the shutdown utility – ClientMate to protect your Windows operating
system. And also could use the UPS management software – SNMPView, to control and
management multiple UPS on the network.
Fig.4 NetAgent UPS installation flowchart
Setup the NetAgent IP address or
update firmware by using
Netility (Chapter 4)
The NetAgent management utility –
SNMPView could be used
to manage multiple NetAgent
Using the shutdown utility
– ClientMate to
connect to NetAgent UPS
Using the Telnet to configure
the NetAgent UPS settings
(Chapter 6)
Using the Brower to connect to
NetAgent by using the IP address of
it. (Chapter 5)
Connect the NetAgent, UPS
and Network (Chapter 3)
To Next Page
Loading...
Need help?
General