Operation
SMART KNIT - 3.11 -
Operating Sequences
The
SMART KNIT system allows you to carry out the following set of functions:
!
Programming the parameters that affect the system operation, through a
number of interactive menus.
"
Continuously monitoring the machine production, indicating the errors
detected with respect to the control algorithm set with the P_ABCD function
(broken or missing yarns, uncut yarns, etc.) and stopping the machine when
the detected errors exceed the set tolerances
.
#
Performing the sensor test as well as the communication test between
SMART KNIT terminal and SM-DIN modules and between SM-DIN
modules and sensors, in case of failures.
When the system is turned on, after the initial diagnostic phase, SMART KNIT
immediately gets into monitoring phase (CONTROL).
➩
➩➩
➩
To access the setting/changing menus of system operation parameters press and
hold for 3 seconds
The following pages describe in details the various operating sequences
concerning the system programming and use.
To Next Page
Loading...
