Style Programming
SMART MATRIX WINDINGFEEDER - 25 -
Style Programming
This function allows you to program the operation parameters of WINDINGFEEDER devices.
The STYLE EDIT function provides 3 options selectable using the immediate activation buttons.
To create a “new” style and add it to the style database.
To either change the parameters of an existing style, or to create a new style starting from a
similar already existing style.
To remove a style from the database.
You may assign different tension and control parameters to each style, in order to meet your specific
application needs.
The STYLE EDIT function requires the programming of 3 sets of parameters in 3 windows (PROFILE, ADV
and CONFIG).
Programming a new style
Select STYLE EDIT.
Press ADD
(the
indicates that WINDINGFEEDERC is the style
currently loaded to the device)
Parameters Programming within the PROFILE window
Setup in sequence the parameters of PROFILE
window.
Graphic profile of the yarn tension depending on
programmed values.
For the explanation of the various parameters,
please refer to Section 3 “Summary table of Style
Programming Parameters” and “Profile Programming
Examples
STYLE EDIT
To Next Page
Loading...
