burmeier Regia - Dismantling the Care Bed

10 Dismantling the Care Bed
• Move the backrest, thigh rest and lower leg rest to a horizontal position.
• Move the mattress base to the highest position.
• Disconnect the switch mode power supply plug from the mains socket.
• Remove the safety sides. Caution: Do not let them drop!
• Dismantle the side panel.
• Dismantle the headboard and footboard.
• Remove the fixing bolts for the backrest motor and place the backrest motor on the
floor.
• Remove the fixing bolts for the thigh rest motor and place the thigh rest motor on the
floor.
• Undo the connection screws on the mattress base at the head and foot end.
• Take the mattress base off.
• Reinsert the plug of the switch mode power supply into the mains socket.
• Move the chassis to the lowest position.
• Disconnect the switch mode power supply plug from the mains socket.
• Insert the backrest motor and thigh rest motor in their transport position and secure
these with bolts.
• All loosened screws should be re-tightened for transport, and the plug cover should be
put back in position (to prevent it from getting lost).
Part B: Operator and Technical Personnel 65