burmeier Regia - Side Panels; Split Side Panels

3.5 Side panels
3.5.1 Split side panels
WARNING
1 Use a finger to pull the orange safety
lock [1] towards the centre of the bed
and keep holding it in this position.
2 Swivel the locking levers [2] (left and
right side) downwards.
3 Standing behind the headboard/foot-
board, firmly grip the uppermost cor-
ners of the headboard/footboard with
both hands.
4 Pull the headboard/footboard straight
up and then outwards out of the slits in
the cross tube, as evenly as possible.
The bed can optionally be fitted with side panels. A total of four side panels are needed: 2 x
long (110 cm) and 2 x short (90 cm). 1x short and 1x long side panel are mounted on each
side of the bed. When fitting a bed extension at a later date, the short side panels must be
replaced with longer ones.
Risk of injury
Failure to heed this warning may result in entrapment or falls due to incorrect assembly/
storage of split safety sides/headboard and footboard/side panels with “Easy Switch” sys-
tem!
•
Please carefully follow the assembly steps described below.
Assembling the Care Bed
18 Part B: Operator and Technical Personnel