3.9.1.2 Lowering
CAUTION
Fully-raised safety side Angled position of the top bar
The split safety sides can be lowered in two stages (telescopic)
Risk of injury!
Failure to heed this warning may result in physical injury due to entrapment and crushing.
•
Be careful with fingers when adjusting and lowering the safety side. These can be crush-
ed between the bed frame and the safety side!
Proceed as follows:
• First relieve the load on the safety side by lifting it slightly.
• Then press both release buttons for the upper bar [1] and lower the safety side.
• Repeat this procedure for the middle bar (release buttons [2]).
Operation
24 Part C: Care staff and residents
To Next Page
Loading...
