BUSCH MINK - Speed Control

7 | Commissioning
22 | 40 Instruction Manual MINK MV 0500-0600 B_EN_en
7.1.3 Speed Control
NOTICE
Changing of any other parameters than described below.
Risk of damage to the machine!
● Do not change any other parameter than described below.
NOTE: VSD parameter settings for speed control
– MV 0500 B - T434216016
– MV 0600 B - T434200760
NOTICE
Motor speed exceeds the permitted motor speed range.
Risk of damage to the machine!
● Check the Technical Data [➔35] for permitted motor speed range.
● Make sure to comply with it.
Change Values
Range of settings: 20 Hz … 60 Hz