8 | Maintenance
56 / 68 0870211676_RA0760A_PLUS_-0004_IM_en
8.2 Oil Level Inspection
If the oil level is too low, an alarm signal will be sent by the monitoring system.
To check the oil level status:
• Go to “HOME” > “MONITORING”.
• In the cell “Oil level” it must always be written “OK”.
To perform a visual control of the oil level:
• Check the oil sight glass (OSG).
Remove central
front cover
Quarter turn
key
(delivered loose)
8.3 Oil and Oil Filter Change
NOTICE
Use of an inappropriate oil.
Risk of premature failure!
Loss of efficiency!
• Only use an oil type which has previously been approved and recommended by
Busch.
NOTICE
Change oil from mineral to synthetic or the other way around.
Risk of using a deteriorated oil!
Risk of premature failure!
By default, the oil temperature thresholds (warning/alarm) and the service intervals are
configured according to the oil type (mineral or synthetic) written on the nameplate
(NP).
In case of oil type change:
• Contact your Busch representative to adapt the thresholds and service intervals ac-
cordingly.
To Next Page
Loading...
