CAB EOS User Manual

26 26
27
7 Maintenance
7.5 Cleaning Cutter and Replace Blades
!
Warning!
 Disconnect printer from electrical outlet to prevent accidental
blade movement.
!
Warning!
Risk of injury! The cutter blades are sharp!
i
Notice!
When cutting through the label material instead of the label gap
remains of adhesive may accumulate on the blades. If operating in
backfeed mode, such remains of adhesive may be deposited on the
drive roller as well.
 Clean the drive roller and the cutter blades often.
1
2
3
4
Fig. 19 Dismount Cutter
1. Fold down cutter.
2. Push release push button (1) and lift blade unit (3) from the cover (4).
3. If the blades are only slightly dirty it is sufcient to clean them with a soft
cloth and continue with point 5.

CAB EOS Specifications

General

Power Supply	100-240V AC, 50/60 Hz
Print Method	Thermal transfer
Print Width	Up to 105.6 mm (depending on model)
Interfaces	USB, Serial, Ethernet
Display	LCD
Supported Barcodes	Code 39, Code 128, UPC-A, UPC-E, EAN-8, EAN-13, Interleaved 2 of 5, Data Matrix, QR Code
Supported Operating Systems	Windows
Resolution	203 dpi
Media Width	4.33" (110 mm)