CAB EOS User Manual

32 32
33
Error message Cause Remedy
Structural
err.
Error in the le list of the
data medium, data access is
uncertain.
Format data medium.
System Error
e.g. FPGA defective, invalid
setup, voltage error
Switch the printer off and then
on. Please note error details
shown on the display.
If error recurs call service.
Unknown card
Data medium not formatted. Format data medium.
Type of data medium not
supported.
Use different type of data
medium.
USB error
e.g. Too much current, no
reaction, unknown device
Do not use the USB device.
Write error
Hardware error Repeat the write process,
reformat card.
Write
protected
Data medium write protection
is activated.
Deactivate the write protection.
Table 5 Error Messages and Fault Correction
8 Fault Correction

CAB EOS Specifications

General

Power Supply	100-240V AC, 50/60 Hz
Print Method	Thermal transfer
Print Width	Up to 105.6 mm (depending on model)
Interfaces	USB, Serial, Ethernet
Display	LCD
Supported Barcodes	Code 39, Code 128, UPC-A, UPC-E, EAN-8, EAN-13, Interleaved 2 of 5, Data Matrix, QR Code
Supported Operating Systems	Windows
Resolution	203 dpi
Media Width	4.33" (110 mm)