17
4 Loading Material
1. Open the cover and hinge down the control panel.
2. Press the release button and hinge the print module up.
3. Press the ribbon supply hub (2) to the right until there is perceptible resistance, pull it to the left out of the guide
slot (1) and remove it.
4. Set the width of the ribbon roll on the ribbon supply hub (2). For that purpose press the lever (4) and move it
sidewards. The set roll width is shown on the scale (3) of the ribbon supply hub (2).
5. Slide the ribbon roll onto the ribbon supply hub (2) until the lever (4). Ensure that the coated side of the transfer
ribbon (7) is facing to the label stock.
6. To insert the ribbon supply hub (2) again press the rectangular end (5) of the hub against the spring in the right-
hand holder, and slide the left-hand end into the guide slot (1) as far as it will go.
7. Hinge the print module down (do not slot in).
8. Insert an empty roll (10) for the used transfer ribbon onto the ribbon rewind hub (9) and set the width for the empty
roll similarly to steps 3 to 5.
9. To insert the transfer ribbon rewinding unit (9) again press the rectangular end (5) of the hub against the spring in
the right-hand holder, and slide the left-hand end into the guide slot (6) as far as it will go.
10. Feed the transfer ribbon (7) over the printhead to the ribbon rewind hub (9), and attach the ribbon to the empty roll
with adhesive tape.
Ensure that it is wound as shown in the gure and ensure that the ribbon is not twisted.
11. Turn the tension wheel (11) in the winding direction until the ribbon is tightly wound on the roll.
12. Slot in the print module by pressing the marked surfaces (8) on both sides, hinge up the control panel and close
the cover.
To Next Page
Loading...
Need help?
General
