Cadel KRISS3 - Stove Door Removal;Installation; Evo Side Panels Assembly

KRISS
3
- TECNA
3
- EVO
3
- ELISE
3
- SHELL
3
- CRISTAL
3
- GLASS - VERVE AT - PRETTY AT - TITANIA AT - VENERE AT - BREEZE AT
22
LEGEND Fig. 30
1 Stove
2 Minimum lateral distance = 200 mm
3 Minimum rear distance = 200 mm
4 Minimum front distance = 1000 mm
It is obligatory to install the stove away from walls and/or pieces of furniture, with a minimum air flow of 200 mm on the sides and
200 mm on the back, to enable an eficient appliance cooling and a good distribution of heat in the room (see Fig. 30).
If the walls are made up of flammable materials, check the safety distances (see Fig. 30).
At maximum power check that the wall temperature does not ever exceed 80°C. If it would be necessary please install a fire re-
sistant plate on the concerned walls.
In some countries also masonring load-bearing walls are considered flammable.
5.4 STOVE DOOR REMOVAL/INSTALLATION
DOOR REMOVAL
For some operations (e.g.: side panel assembly and cleaning) you must remove the stove door.
To remove the door:
• Open the door.
• Use a screwdriver to rotate the lever in the direction of the arrow (see Fig. 31).
• Lift the door to allow the door pivots to slide out of the structure bracket (see Fig. 32).
• Keep the door in a safe place until next use.
Fig. 31 - Remove screws Fig. 32 - Door removal
DOOR ASSEMBLY
To assemble the door you must centre the pivots fixed to the door, on the structure bracket.
After having mounted the door with the screwdriver, lift the lever so that the door is locked.
5.5 EVO
3
SIDE PANELS ASSEMBLY
• Remove the cover: loosen the 4 upper screws (see Fig. 33).
• With your finger, fold the upper flaps which are located on the black profiles outwards (see Fig. 34).
• Insert the side panels into the corresponding guides letting them slide slowly down to the base (see Fig. 35).
• Reposition the cover by centring the special teeth (see Fig. 36).