3.
Tune
in
the desired station.
4.
Press and hold one
of
the six numbered buttons for
more than two seconds until you hear a beep.
Whenever
you
press that numbered button for less
than two seconds,
the
station
you
set will return.
5.
Repeat the steps for each pushbutton.
When battery power is removed and later applied,
you
will not have
to
reset your radio presets because the
radio remembe,rs them.
Setting the Tone
BASS:
Press this knob lightly
so
it
extends. Turn
the knob to
the
right to increase
and
to
the left to
decrease bass.
PRESET
SCAN:
Press and hold
SCAN
for two to three
seconds
until
PRESET
SCAN
appears
on
the display to
listen
to
each
of
your preset stations for a few seconds
(factory presets which have not been reprogrammed
with your stations will be ignored).
The
radio will
go
to
the first preset station stored on your pushbuttons, stop
for a few seconds, then go
on
to
the next preset station.
Press
SCAN
again to stop scanning. If a preset station
has weak reception, the radio will not stop at the
preset station.
TREB:
Press this knob
lightly
so
it
extends. Turn the
knob to the right
to
increase and
to
the
left to decrease
treble.
If
a station
is
weak or
noisy.
you
may want to
decrease the treble.
Push these
knobs
back into their stored positions when
you’re not using them.
Adjusting the Speakers
BAL:
Press
this knob lightly
so
it
extends. Turn the
knob to
the
right
to
adjust sound
to
the right speakers
and
to
the
left
for the
left
speakers. The middle position
balances the sound between the speakers.
FADE:
Press this knob lightly
so
it
extends.
Turn
the
knob
to the right to adjust the sound
to
the
front
speakers and to
the
left for the rear speakers. The middle
position balances the sound between the speakers.
Push these knobs back into
their
stored positions when
you’re not using them.
3-11
To Next Page
Loading...
