Playing
a
Cassette Tape
With the radio on, insert a cassette tape. The tape will
begin playing as soon as it is inserted. When one side of
your cassette tape is done playing, auto reverse plays the
other side of your cassette tape. If you want to insert a
cassette tape when the ignition is off, first press EJECT.
While the tape is playing,
use
the
VOL,
FADE,
BAL,
BASS and
TREB
controls just as you do for the radio.
Other controls may have different functions when a tape is
inserted. The display will show TAPE with
an
arrow to
indicate which side
of
the tape
is
playing. PLAY will
appear
on
the display temporarily when a tape is playing.
The display will then revert back to showing the time.
If an error occurs while trying to play a cassette tape,
it
could
be
that:
The cassette tape is tight and
the
cassette player
cannot turn the hubs of
the
tape. Hold the cassette
tape with the open end down and try turning the right
hub
to
the left with a pencil. Flip the tape over and
repeat. If the hubs
do
not
turn
easily, your cassette
tape may be damaged and should
not
be used in
the
player.
Try
a new tape
to
be sure your player is
working properly.
The cassette tape is broken. (Check
to
see
if
your
tape is broken. Try a new tape.)
REV
Press
the left arrow to rewind the tape rapidly.
The radio will play while the tape reverses and
REV
will appear on
the
display. You may use your station
pushbuttons to tune to another radio station while in
REV
mode. Press
the
left arrow again
to
return
to
playing speed.
FF:
Press the right arrow to fast forward to another part
of the tape.
The
radio will play while the tape advances
and
FF
will appear
on
the display. You may use your
station pushbuttons to tune to another radio station while
in
FF
mode. Press the right arrow again
to
return
to
playing speed.
SEEK-TUNE:
Press the right arrow to seek to the next
selection
on
the tape. Press the left arrow to search for
the previous selection'on the tape
(REP
will appear
on
the display). Your tape must have at least
three
seconds
of silence between each selection for SEEK-TUNE to
work. The sound will mute while seeking.
SCAN:
Press this button.
SCAN
FF
will appear
on
the
display
until
the next selection is found and
then
SCAN
PLAY will appear
on
the
display. Use SCAN
to
listen to
selections for a few seconds. The tape will
go
to
a
selection, stop for a few seconds, then go on to the next
selection. Press this button again to stop scanning.
SIDE:
Press
this
button
to
change the side
of
the tape
that is playing. (PLAY shows on the display.)
3-12
To Next Page
Loading...
