Playing
a
Cassette
Tape
With the radio
on,
insert a cassette tape. The tape will
begin playing as soon
as
it is inserted. When one side of
your cassette tape is done playing, auto reverse plays the
other side
of
your cassette tape. Cassette tapes may be
loaded with the radio off but they will not start playing
until the radio is on. If you want to insert a cassette tape
when the ignition is
off,
first press EJECT.
While the tape is playing, use the VOL,
TONE,
LEVEL
and
DSP
controls just as you
do
for the radio. Other
controls may have different functions when a tape is
inserted. The display will show an underlined tape
symbol.
TAPE
PLAY
will appear
on
the
display when a
tape is playing, with an arrow
to
indicate which side of
the tape
is
playing.
If
an error occurs while trying to play a cassette tape, it
could be that:
The cassette tape
is
tight and the cassette player
cannot
turn
the hubs of the tape. Hold the cassette
tape with the open end down and try turning the right
hub to the left with
a
pencil. Flip the tape over and
repeat. If the hubs do
not
turn easily, your cassette
tape may be damaged and should not be used in the
player. Try a new tape to be sure your player is
working properly.
The cassette tape is broken. (Check to see if your
RW:
Press the left arrow to rewind the tape rapidly. The
radio will play while the tape rewinds. You may
use
your station pushbuttons to tune to another radio station
while in RW
mode.
Press the left
arrow
again
to
return
to playing speed.
tape is broken.
Try
a new tape.)
3-24
To Next Page
Loading...
