FF:
Press the right arrow to fast forward
to
another part
of
the tape. The radio will play while the tape advances.
You may use your station pushbuttons to tune
to
another
radio station while in
FF
mode. Press the right arrow
again
to
return to playing speed.
TUNE-SEEK:
When this button
is
pressed,
it
has two
positions. This button works the same, whether it is
pressed
to
the first or second position. Press this button
to seek to the next or previous selection
on
the tape.
Your tape must have
at
least three seconds of silence
between each selection
for
TUNE-SEEK
to
work.
The
sound will mute while seeking.
SCAN:
Press this button to listen to selections for a few
seconds.
The
tape will go to a selection. stop for a few
seconds, then go on to the next selection. Press this
button again
to
stop scanning.
SIDE:
Press this button to change the side of the tape
that is playing.
/1\
EJECT
Press the upward triangle button
to
remove a tape. The radio will play. Eject may be
activated with the radio
off
and/or the vehicle
ignition off.
CLEAN
TAPE:
If
this message appears
on
the display,
the cassette tape player needs
to
be cleaned. It will still
play tapes, but
you
should clean it
as
soon as possible to
prevent damage to the tapes and player. See “Care
of
Your Cassette Tape Player” in the Index. After
you
clean
the
player, press and hold EJECT for three seconds
to
reset the CLEAN TAPE indicator.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks of Dolby
Laboratories Licensing Corporation.
Auto Cr02 allows the cassette tape player
to
adjust to
the
type of cassette tape for clearer sound for Cr02
cassette tapes.
3-25
To Next Page
Loading...
