CAE Luna - Care and Maintenance; General Simulator Care

©2022 CAE 905K560252 v1.2 65
Care and Maintenance
CARE AND MAINTENANCE
Maintaining the simulator requires careful treatment of electronic and mechanical components. After
use, make sure all components are properly handled and correctly removed or placed into storage.
Note: Many hardware components of the simulator and the Instructor Workstation are not user-
serviceable. The SymDefib unit is also not user-servicable and must be returned to CAE Healthcare
if repair is needed. Contact CAE Healthcare Customer Support for any questions and concerns
regarding hardware maintenance.
General Simulator Care
• Avoid the use of writing instruments and sharp objects near the patient simulator to
prevent tears or unattractive markings in or on the skin.
• A mild detergent and warm water will remove most marks and stains. Gently rub the
soiled area with a soft cloth. DO NOT use ABRASIVE soaps or pads.
• Lubricate airway adjunctswith cottonseed oil spray prior to insertion. DO NOT use water-
based lubricant.
• Prior to using moulage of any kind, and to make cleansing the simulator’s skin easier,
lightly apply petroleum jelly to the simulator’s skin, followed by a light amount of talcum
powder (unscented baby powder).
• If the IV sites have been used, remove the fluid as described in the breakdown procedure.
Failure to drain and clean the systems may cause problems with the system.
• If the IM injection site(s) have been used, remove the fluid from the sponge inside the
injection site pad as described in the breakdown procedure.
Storage
IMPORTANT: Do not attempt to open or repair any simulator components. Doing so may void the
warranty. If damage exists, contact CAE Customer Service immediately for a repair. Prompt repair
prevents expansion of the damaged area.
CAUTION
Do not attempt to open or repair any simulator components without authorization from CAE
Customer Support. Doing so may void the warranty.