#9 Viper_SC_Manual_001-5008-000_Rev12e.docx | Page 25
Encryption: Select to Enable. Default = Disabled.
If encryption is enabled, you must enter an Encryption Pass Phrase. This phrase must be the same for all units in the
network. The default pass phrase is Dataradio.
Click Apply. Click Next.
STEP 5
Figure 16 – Setup Wizard (STEP 5)
Click Done. Click Save Config to save the network parameters for your Viper SC. You will see a green success icon on the
bottom left of the page when save is complete. Click Reset Unit to cycle device power. This is necessary if you changed any
parameters marked with a yellow!
You have completed the Viper Setup Wizard. Your unit is now functioning in Bridge Mode.
To Next Page
Loading...