Calsense CS3000 User Manual

CS3000 User’s Guide
50 Calsense
Unlinking Orphan POC Decoders
Sometimes, POC decoders are removed from the system. For example, if a decoder has been damaged,
it may need to be replaced with a new decoder. After removing a decoder and performing a 2-Wire
discovery, the POCs assigned to that decoder may be orphaned. This means the POC will no longer
operate until it is assigned to a new decoder.
When an orphaned POC is detected following a discovery, the Unlink Orphan 2-Wire POCs menu option
appears on the 2-Wire dialog. This allows these POCs to be unlinked from the missing decoder, thereby
making them available to assign to a new decoder.
To Unlink Orphan 2-Wire POCs (Figure 39):
1. From Main Menu, navigate to Setup and select 2-Wire. The 2-Wire dialog displays.
2. Navigate to and select Unlink Orphan 2-Wire POCs. The Unlink Orphan 2-Wire POCs screen
displays.
3. Navigate to the desired Decoder S/N and press SELECT to unlink the POC assignment.
Note: If the decoder is part of a bypass manifold, it is removed from the bypass manifold which
will cause the bypass manifold not to function until another decoder is added to it
4. When finished, press BACK to save changes, and return to Main Menu.
Figure 39: Unlink 2-Wire POCs Screen

Calsense CS3000 Specifications

General

Brand	Calsense
Model	CS3000
Category	Controller
Language	English