CS3000 User’s Guide
Calsense 51
Manual Water Operations
There are many features in the CS3000 that allow for specific water adjustments to accommodate all
water management needs. These real time water adjustments are typically used to add additional
watering or test repaired stations.
Testing Stations
The Test Stations feature provides the ability to test a station or acquire an expected flow rate for a
station. When a station is being tested, it will ignore On-At-A-Time and flow checking rules.
Note: If testing a station while other irrigation is running, the other irrigation will be paused until the
test completes.
To test a station (Figure 40):
1. From Main Menu, navigate to Manual & Test and select Test Stations. The Test Stations screen
displays.
2. Use +/- to select desired station. If the controller is part of a FLOWSENSE® chain, make sure
you select the correct controller as well.
3. To adjust the amount of time to test the station for, navigate to Run test for and use +/-.
4. Navigate to and select Turn on. The station turns on and the Irrigation details screen displays
with information about all stations that are running, soaking, or waiting to run.
Note: To stop a station that is running from the Irrigation Details screen, highlight the station and press
SELECT. The station stops and the next station turns on.
To acquire the expected flow rate for a station:
Note: To acquire the flow rates of all the station within a Station Group at the next scheduled irrigation,
see Acquire Flow Rates
.
1. From Main Menu, navigate to Manual & Test and select Test Stations. The Test Stations screen
displays.
Figure 40: Test Stations Screen
To Next Page
Loading...
Need help?
General
