CS3000 User’s Guide
52 Calsense
2. Navigate to and select Acquire Flow to acquire an expected flow rate. The station turns on and
the Irrigation details screen displays with information about all stations that are running,
soaking, or waiting to run.
Once this process starts, the station will irrigate for up to six-minutes to allow the irrigation lines to fill
and for the system to gain stability before acquiring the flow rate. If the flow remains unstable for the
duration of the test, the flow rate is not acquired, and an alert is generated.
Manually Watering
The Manual Watering feature provides the ability to manually water a station or a station group to
supplement or make-up irrigation.
Note: If other irrigation is running when Manual Watering starts, the other irrigation will be paused until
the Manual Watering completes.
To manually water a station (Figure 41):
1. From Main Menu, navigate to Manual & Test and select Manual Watering. The Manual
Watering screen displays.
2. Use +/- to select desired station to manually water. If the controller is part of a FLOWSENSE®
chain, make sure you select the correct controller as well.
3. To adjust the amount of time to water the station for, navigate to Run station for and use +/- to
adjust run time. The default is the station’s scheduled approximate run time.
4. Navigate to and select Run Station. The station turns on and the Irrigation details screen
displays with information about all stations that are running, soaking, or waiting to run.
To manually water a Station Group (Figure 41):
1. From Main Menu, navigate to Manual & Test and select Manual Watering. The Manual
Watering screen displays.
2. Navigate to Manual Water and use +/- to select the Station Group to water.
Figure 41: Manual Watering Screen
To Next Page
Loading...
Need help?
General
