CAME ZLJ24 - Additional Time Setting Parameters; M2 Delayed Closing Time; Pre-flashing and Lock Time Settings; Ram Blow Time Configuration

X 2
X 4
X 2
X 5
X 2
X 6
X 2
X 7
Pag.
24
24 - Manual code:
319U98EN
319U98EN ver.
2
2 06/2013 © CAME cancelli automatici s.p.a. - The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
< Cl. Delay M2 >
2s
Cl. Delay M2
< 2s >
M2 delayed closing: the waiting time of the (M2) second gate leaf, unlike the (M1) first one, after each closing command. the waiting
time can be set to between 0” and 60”.
Cl. Delay M2
< 3s >
<Preflashing T.>
5s.
Preflashing T.
< 5s. >
Pre-flashing time: after an opening or closing command is given, the flasher connected to (10-E), flashes for between 1” and 60”,
before the gate begins to move.
Preflashing T.
< 6s. >
TIMING ADJ.
US
ER
S
INF
O
ENCODE
R
I
m
p
.
R
u
n
TIMING ADJ.
U
S
ER
S
INF
O
EN
CO
DE
R
Imp. Ru
n
< Lock time >
2s.
Lock time
< 2s. >
Lock time: the time required for releasing the electro-lock after each opening command. The time of operation can be set to between
1” and 5”.
Lock time
< 3s. >
< Ram hit time >
2s.
Ram hit time
< 2s. >
Ram blow time: the gearmotor’s thrust time when fully closing and opening after each command .The thrust time can be set to
between 1” and 3”.
Ram hit time
< 3s. >
TIMING ADJ.
U
S
ER
S
INF
O
EN
CO
DE
R
Im
p
. Ru
n
TIMING ADJ.
US
ER
S
INFO
E
NCODE
R
Im
p
. Run