CAME ZLJ24 - Output Mode and Gate Run Settings; B1-B2 Output Mode Selection; Gate Run Parameter Configuration; Number of Motors and Motor Type

X 2
X 2
X 17
X 2
X 2
X 2
Pag.
17
17 -
Manual code
:
319U98EN
319U98EN
ver.
2
2 06/2013 © CAME cancelli automatici s.p.a. -
The data and information reported in this installation manual are susceptible to change at any time and without obligation on CAME cancelli automatici s.p.a. to notify users.
ENGLISH
<
LAN
G
UA
G
E
>
E
ng
li
s
h
FUN
C
TI
O
N
S
TIMING ADJ.
US
ER
S
Imp. Run
< LAN
GU
A
G
E
>
E
ng
li
s
h
FUNCTIONS
TIMING ADJ.
USERS
I
m
p
. Run
B1-B2 output: setting contact B1-B2 to MONO-STABLE or BI-STABLE (switch) mode.
Number of motors: setting the number of motors, either one or two, depending on the number of gate leaves installed on the system.
< output B1-B2 >
Monostable
output B1-B2
< Bistable >
output B1-B2
< Monostable >
>
7.7 Gate-Run Setting Menu
Motor Type: setting up the type of swing gate motor installed in the system.
% speed of action: setting up the speed during gate operation, expressed as a percentage between 50% and 100%.
< Motor type >
FROG
Motor type
< FROG >
Motor type
< AMICO >
Motor type
< AXO >
Motor type
< FROG-J >
Motor type
< FAST >
Motor type
< FERNI >
< High speed % >
50
High speed %
< 50 >
High speed %
< 51 >
< No. Motors >
M1 + M2
No. Motors
< M1 + M2 >
No. Motors
< M2 >
<
LAN
GU
A
G
E
>
E
n
g
lish
FUNCTION
S
TIMIN
G
AD
J
.
US
ER
S
Imp. Run
< LAN
GU
A
G
E
>
E
n
g
lish
FU
N
C
TI
O
N
S
TIMIN
G
AD
J.
US
ER
S
Imp. Run