Campbell CR1000X - Device Configuration Utility Settings (Continued)

Keyword Information and Location
TLSPassword
This setting specifies the password that will be used to decrypt the TLS
Private Key setting.
l String data type
Where to find:
l Settings Editor tab in Device Configuration Utility: TLS | Private
Key Password (setup available over USB or RS-232 only)
TLSStatus
Reports the current status of the datalogger TLS network stack.
l String data type
l Read only
Where to find:
l Settings Editor tab in Device Configuration Utility: TLS | TLS Status
UDPBroadcastFilter
Set to one if all broadcast IP packets should be filtered from IP
interfaces. Do not set this if you use the IP discovery feature of the
device configuration utility or of LoggerLink. If this is set, the datalogger
will fail to respond to the broadcast requests.
Default = 0.
l Numeric data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Advanced | IP
Broadcast Filtered
9. Tips and troubleshooting 159