LoggerNet users, select the Main category and Connect on the LoggerNet toolbar, select the
data logger from the Stations list, then click Connect . Once connected, select a table to view
using the Table Monitor.
4.2 Collecting data
The data logger writes to data tables based on intervals and conditions set in the CRBasic
program (see Creating data tables in a program (p. 36) for more information). After the program
has been running for enough time to generate data records, data may be collected by using data
logger support software. During data collection, data is copied to the computer and still remains
on the data logger. Collections may be done manually, or automatically through scheduled
collections set in LoggerNet Setup. Use these instruction or follow the Collect Data Tutorial .
4.2.1 Collecting data using LoggerNet
1.
From the LoggerNet toolbar, click Main and Connect , select the data logger from the
Stations list, then Connect .
2.
Click Collect Now .
3. After the data is collected, the Data Collection Results window displays the tables collected
and where they are stored on the computer.
4. Select a data file, then View File to view the data. See Viewing historic data (p. 30)
4.2.2 Collecting data using PC200W or PC400
1.
Click Connect on the main PC200W or PC400 window.
2. Go to the Collect Data tab.
3. Select an option for What to Collect. Either option creates a new file if one does not
already exist.
l New data from datalogger (Append to data files): Collects only the data in the
selected tables stored since the last data collection and appends this data to the end
of the existing table files on the computer. This is the default, and most often used
4. Data 29
To Next Page
Loading...
