Keyword Information and Location
UTCOffset
Specifies the offset, in seconds, of the datalogger's clock from
Coordinated Universal Time (UTC, or GMT). For example, if the clock is
set to Mountain Standard Time in the U.S. (-7 Hours offset from UTC)
then this setting should be -25200 (-7*3600). This setting is used by the
NTPServer setting as well as EmailSend() and HTTP(), which require
Universal Time in their headers. This setting will also be adjusted by the
Daylight Savings functions if they adjust the clock.
If a value of -1 is supplied for this setting, no UTC offset will be applied.
l Numeric data type
Where to find:
l Settings Editor tab in Device Configuration Utility: Advanced | UTC
Offset
Verify
This setting specifies the interval, in units of seconds, that will be
reported as the link verification interval in the PakBus hello transaction
messages. It will indirectly govern the rate at which the datalogger will
attempt to start a hello transaction with a neighbour if no other
communications have taken place within the interval.
l Numeric data type
Where to find:
l Settings Editor tab in Device Configuration Utility: ComPorts
Settings | Verify Interval
l Settings Editor tab in Device Configuration Utility: Advanced |
Verify Interval Internet
Keyword Information and location
9. Tips and troubleshooting 161
To Next Page
Loading...
