beacon
A signal broadcasted to other devices in a PakBus network to identify "neighbour"
devices. A beacon in a PakBus network ensures that all devices in the network are aware
of other devices that are viable. If configured to do so, a clock-set command may be
transmitted with the beacon. This function can be used to synchronize the clocks of
devices within the PakBus network.
binary
Describes data represented by a series of zeros and ones. Also describes the state of a
switch, either being on or off.
BOOL8
A one-byte data type that holds eight bits (0 or 1) of information. BOOL8 uses less space
than the 32 bit BOOLEAN data type.
boolean
Name given a function, the result of which is either true or false.
boolean data type
Typically used for flags and to represent conditions or hardware that have only two states
(true or false) such as flags and control ports.
burst
Refers to a burst of measurements. Analogous to a burst of light, a burst of meas-
urements is intense, such that it features a series of measurements in rapid succession,
and is not continuous.
C
calibration wizard
The calibration wizard facilitates the use of the CRBasic field calibration instructions
FieldCal() and FieldCalStrain(). It is found in LoggerNet (4.0 and later) or RTDAQ.
Appendix A. Glossary 178
To Next Page
Loading...
